Detection Systems DS7060 Uživatelský manuál stáhnout pdf (Strana 3)

4/98

DS7060-AUS Reference Guide Copyright  1997-98 Detection Systems, Inc. Page 3

(1&/2685(,167$//$7,21

The DS7060 control/communicator and the enclosure

are shipped together. The control, however, still needs

to be installed into the enclosure. Hardware for

mounting the enclosure to a wall, and the control to

the enclosure is located in its own hardware pack.

NOTE: This panel is intended for mounting in a

restricted access area and should be wall

mounted.

CAUTION: The control panel should only be

installed by authorized service

personnel.

• Use the enclosure as a template and mark the

mounting holes on the mounting surface.

• Pre-start the mounting screws for these holes.

Mount the enclosure.

• Knock out the desired wire entrances on the

enclosure.

CAUTION: The control is static sensitive. Make sure

you touch earth ground before handling

the control. This will discharge any static

electricity in your body.

EXAMPLE: Run the ground wire to the enclosure

before handling the control. Then,

holding the ground wire (or using a

ground strap), install the control.

• Insert the two support posts into the control retainer

holes as shown below in the Support Post

Assembly diagram.

• Slide the top of the control PCB into the two retainer

tabs.

• Once in the retainer tabs, the control will rest on the

two support posts.

• Secure the bottom of the enclosure by screwing the

bottom two holes through the support posts and

through to the control retainer holes.

CAUTION: Once the control is installed, be sure to

connect its ground wire to the top hinge

of the enclosure.

1 2 3 4 5 6 7 8 ... 23 24

Žádné komentáře

Detection Systems DS7060 Uživatelský manuál Strana 3