Detection Systems DS7060 Uživatelský manuál Strana 9

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 24
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 8
4/98
DS7060-AUS Reference Guide Copyright 1997-98 Detection Systems, Inc. Page 9
All six zones can be programmed to respond at either
300 ms (±100 ms) or a programmable time (common
to all zones, the time is programmed into Address 06)
that can be configured to be between 160 ms and 2.5
seconds.
Sets the time value used in Address 05.
Restore when Sounders Silence: If programmed,
a zone sends a restoral report and is ready to
activate again only after the burglary bell cutoff time
expires or the bells are silenced. The zone can
alarm multiple times per armed period.
Restore with Zone: If programmed, a zone sends
a restoral report and is ready to activate again as
soon as it physically restores. The zone can alarm
multiple times per armed period.
Restore when Disarmed (or Reset): If the zone
returns to normal before the bell timer elapses, the
alarm display will continue and no restoral will be
reported. When the bell timer then elapses, whether
or not the zone has restored, the bell will shut down
(if selected) but the alarm display will continue and
no restoral will be reported. When the system is
disarmed (or reset) the bell will silence, the displays
will clear and restoral will be reported along with the
open/reset event (if programmed). If the zone is a
24 hour zone and has not restored to normal, will
not report zone restoral until the zone restores.
Unrestored 24 hour zones will show as “not ready”
and will prevent the system from arming. In this
case, the system will reinitiate the sounders and
displays for those zones, but will not send any fire
alarm transmission to the central station for those
zones, unless a previous restoral has been sent.
Fire zones always restore when the system is reset,
regardless of this selection.
Zobrazit stránku 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Komentáře k této Příručce

Žádné komentáře